ASROCK 4Core1600Twins-P35, Installation Manual

Page: 22 / 183

2 2 2 2
2 2 2 2 2 2
ASRock 4Core1600Twins-P35 Motherboard
EnglishEnglishEnglishEnglishEnglish
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 9)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATAII_1 (Port0):
connectors support SATA data
see p.2, No. 12)
cables for internal storage
(SATAII_2 (Port1):
devices. The current SATAII
see p.2, No. 16)
interface allows up to 3.0 Gb/s
(SATAII_5 (Port4):
data transfer rate.
see p.2, No. 11)
(SATAII_6 (Port5):
see p.2, No. 17)
SATAII_6 (Port5) connector can be used for internal storage device or
be connected to eSATAII connector to support eSATAII device. Please
read “eSATAII Interface Introduction” on page 28 for details about
eSATAII and eSATAII installation procedures.
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
the red-striped side to
Pin1
SATAII_5 (Port4) SATAII_1 (Port0)
SATAII_6 (Port5) SATAII_2 (Port1)