EFD1000 E5 Dual Electronic Flight Instrument (EFI) Install Manual
DOCUMENT # 900-00041-001
PAGE 219-226
REVISION D
© Copyright 2019 Aspen Avionics Inc.
Figure E22: EA100 to Century 4000 Attitude Source w/DISC
2
A/P AHRS FAIL light must be installed in the pilots primary field of view. Use light/dimmer/test switch
P/N MS25041-4. Wire as shown. Use 14v or 28v bulb as appropriate.
3
4
This note is not used
This note is not used
5
6
This note is not used
7
GENERAL INSTALLATION NOTES
All wires in this section 22AWG unless otherwise specified
All grounds should be as short as possible
Terminate all shields within connector back shell
EA100
41
39
3
16
1
P2
AP EXCITE HI
AP EXCITE LO
AP ROLL HI
A/P INTRLK COMM
A/P INTRLK ENERGIZED
17
2
AP PITCH HI
AP PITCH LO
4
2
9
A/P EXCITATION
PITCH GYRO SIG
8
ROLL GYRO SIG
A/P REFERENCE
The existing autopilot disconnect circuit must be run through an internal relay within the EA100. This
ensures the autopilot cannot be engaged or will disengage if the EA100 attitude is invalid. The
autopilot “sonalert” or disconnect tone must not be interrupted with this relay. Wire as shown.
CD176
Remove wire from CD280-4 and install new pin/wire or cut wire and splice on new wire. Run new
wire from CD280-4 to EA100 P2-41.
3
After
A/P DISC IN
CD280
4
TR1 Transformer Interface box must be field fabricated using the instructions in this Appendix.
3
20
22
33
21
CD279
Transformer
Interface Box
(See Figure
E7 for
internal
components
and
connections)
P1
P1
The old wire that was going to CD280-4 (from CD189-3) will need to be lengthened and run to
EA100 P2-39 or install new pin/wire in CD189-3 and run new wire to EA100 P2-39.
6
7
8
9
10
11
1
2
3
4
5
2
43
44
A/P AHRS COMM
A/P AHRS INVALID
A/P AHRS FAIL
A/P circuit
breaker
(existing)
P2
2
1
3
MS25041-4
20 AWG
20 AWG
EA100
1
8
7
8
TR1
Before
A/P DISC Switch OR Century Relay Box (partial)
Existing Wire
A/P
DISC
A/P DISC SW
CD280
4
CD189
3
1
1
11
Existing Wire
Century 4000
(computer)
A/P
DISC
CD189
3
11
Existing Wire
Century 4000
(computer)
Century 4000
(computer)
26
26
18
AP ROLL LO
A/P GND
A/P GND
CD280
