81
7. Factory Default
To recover the default settings of this device, please follow the steps:
1. Power off this device.
2. Use a wire to close the “Default” and “GND” of the Terminal Block.
3. Power on the device, and wait for around 30 seconds to boot the device.
4. Remove the connected wire of the “Default” and “GND”.
5. Re-login the device using the default username (admin) and password (admin).
6. The IP address is probably restored to the default, in this case, use IP Search
utility to search the device. The default IP address is 192.168.1.200
Default
GND
DO
GND
DI
Close “Default” and “GND”
Summary of Contents for CAM6802T
Page 11: ...10 Digital Output Alarm Output Default GND DO GND DI Relay Board or Relay Box ...
Page 36: ...35 Adjust Volume The volume level of Microphone In and Audio Out can be adjusted ...
Page 37: ...36 C Network Setting Network Setting Network Setting ...
Page 48: ...47 settings of mail FTP or Samba network storage are correct ...
