ASL INTERCOM MPS Series, Configuration Manual

Page: 36 / 60

MPS-Series – Configuration Guide
U-0664-0265.doc – Issue: 03 complete, approved
Page 36 of 60
Menu: Config Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # n – name > Æ Paging Microphone >
Æ Buttons Æ Zoning Æ < Button # nn >
Æ DVA Routing or Play DVA or Single DVA route Æ Control Æ Latching Æ ResetButton
•
‘Play Once’ mode
Pressing a ‘DVA Routing’, ‘Play DVA’ or ‘Single DVA’ button plays the DVA associated with the route
once only. When the DVA has completed its full message cycle, the route is terminated.
Example is for a ‘Mind the Gap’ broadcast.
4.6.8.2 DVA Play Mode
Menu: Config Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # n – name > Æ Paging Microphone >
Æ Buttons Æ Zoning Æ < Button # nn >
Æ DVA Routing or Play DVA or Single DVA route Æ Control Æ DVA-Full or DVA-Part
Possible values: ‘DVA-Full’, ‘DVA-Part’
System default configuration: ‘DVA-Full’
The DVA play mode is only relevant for routing DVAs.
If the DVA is configured to ‘Play Once’, then this setting should be ‘DVA-Full’.
Configure the DVA assigned to a ‘DVA Routing’, ‘Play DVA’ or ‘Single DVA’ button to cease playing
when the route is terminated or reset (‘DVA-Part’), or play until its end (‘DVA-Full’).
4.6.8.3 Busy Indication Mode
Menu: Config Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # n – name > Æ Paging Microphone >
Æ Buttons Æ Zoning Æ < Button # nn >
Æ
DVA Routing or Play DVA or Single DVA route
Æ
Control
Æ
Busy=On or Off
Possible values: ‘Busy=On’, ‘Busy=Off’
System default configuration: ‘Busy=On’
Configure whether or not the route associated with a ‘DVA Routing’, ‘Play DVA’ or ‘Single DVA’ button
should cause a busy indication on the LEDs associated with microphone zone select buttons.
If for instance this routing were used for background music control, then the busy LEDs would not
need to be lit. If another type of route were being made, then the busy LEDs would normally be lit.