Asko DBI6442LIG, Operating Instructions Manual

Page: 15 / 28

Care and cleaning
Top up rinse aid
When the rinse aid needs topping up, the above symbol lights on the
display.
Press to open
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked max .
3. Wipe up any splashes of rinse aid around the compartment.
4. Close the lid firmly.
After topping up, it may take a while before the symbol goes out.
Top up salt
When the salt needs topping up, the above symbol lights on the display.
Salt compartment lid
When the salt runs out, unscrew the cap and fill the container with salt.
Water is only needed the first time! Wipe clean and tighten. Run a
programme to ensure that any salt in the dishwasher is rinsed away.
After topping up, it may take a while before the symbol goes out.
WARNING!
In order to avoid rust stains a dishwashing programme must be
started immediately after adding salt.
Never pour dishwasher detergent into the salt compartment. This
destroys the water softener!
Coarse filter
The coarse filter traps larger food particles, which cannot get past the
drainage pump. Empty the coarse filter when necessary.
Coarse filter
1. Lift the coarse filter by the handle.
2. Empty the coarse filter. Remember to refit it!
Fine filter
Debris that collects on the fine filter is automatically rinsed away during
each wash. Clean the fine filter when necessary.
Fine filter
1. Turn the handle anticlockwise.
2. Lift the filter straight up using the handle. Free the coarse filter to
clean the fine filter.
3. Refit in reverse order. Check that the edges seal properly when
refitting the fine filter.
4. Lock the filter in place by turning the handle clockwise to the stop
position. The handle should point straight out from the dishwasher.
NOTE!
Dishwashing results may be
affected if the filters are incorrectly
fitted. Note that the dishwasher
must not be used without the filters
in place!
NOTE!
Check that the coloured stop on
the right in the bottom drain is in
place.
Spray arms
Holes and bearings can sometimes become blocked. Remove any
debris using a pin or the like. The spray arms also have holes
underneath.
To facilitate cleaning you can remove the spray arms. Remember to
fit them firmly back into place afterwards.
Top spray arm
• The upper basket must be removed before the top spray arm can
be released. Pull out the upper basket and turn the basket catch
on each runner outwards (see illustration). The basket can now be
removed.
15