11
3MM
Initiates the patterns
3MM
The second time disables the routine
Command: PEDAL
(Requires Foot Pedal Hardware/Firmware)
Shortcut:
PD
Format:
[Addr#]PEDAL [X=distance] [Y=rate] [Z=multiplier]
Function:
This command sets/displays the dual-pedal footswitch controls for controllers with this
feature. The command is set up as follows: X = Pedal Step Increment size, in
millimeters. Y = Rate when pedal is held down, as an integer proportional to a speed in
millimeters per second, Z = an integer multiplier used when the pedal controls a zoom
axis. It’s a
Card-Addressed command.
Warning:
User must ensure that the Rate given in this command is not greater than the maximum
speed of the axis being controlled by the pedals. Entering an invalid value may result in
unexpected errors and failures.
Reply:
If there are no errors, a positive reply of
:A
followed by the startup sequence.
Example:
1
PD X=0.02 Y=8 Z=5
:A
1PD X? Y?
:A X=0.02000 Y=8.00000
Command: RBMODE
(RING BUFFER Firmware Module Required)
Shortcut:
RM
Format:
[Addr#]RBMODE [X=control] [Y=axis_byte]
[Z=buffer_pointer]
[F=mode_byte]
Function:
Provides control of move and save operations involving the controller’s internal 50-
position ring-buffer (optionally 250 positions, contact ASI). The
LOAD
command is used
to fill the ring buffer.
Summary of Contents for Tiger TG-1000
Page 12: ...11 Change log 53...
