11
Example:
J X?
:A X=2
J X=1
:A
System restart
J X?
:A X=2
J X=105
:A
J X?
:A X=5
1SS Z
:A
System restart
J X?
:A X=5
Command: JSSPD
Shortcut:
JS
Format:
[
Addr#]JSSPD [X=high] [Y=low] [Z=knob_speed]
[F=xy_knobs_high] [T=xy_knobs_low]
Function:
This command sets the relative motor speed for maximum deflection of the joystick to
the values specified. Values between 0.1 and 100 (%) are acceptable, or -100 to -0.1
(negative setting reverses the direction). Pressing the Joystick button toggles between
the
high
and
low
settings.
Knob_speed
is a signed value that sets the relative speed and direction of the encoder
knob (not commonly used on TG-1000).
xy_knobs_high
and
xy_knobs_low
are used to set the fast and slow speeds for
XY_KNOBS
and
ZF_KNOB
, which respond to input from the two knobs on the side of
the TG-1000 joystick. Note this is different from MS-2000 where the
F
parameter set
the low speed and the high speed was given by the low speed multiplied by the
T
parameter raised to the third power. Note that prior to stage firmware version 2.87 the
implementation for
F
and
T
was like MS-2000.
It’s a
Card-Addressed command.
Reply:
If there are no errors, the positive reply “
:A
” will be sent back from the controller.
Example:
1JS X? Y?
:A X=80.000000 Y=3.000000
Summary of Contents for Tiger TG-1000
Page 12: ...11 Change log 53...
