ASI Tiger TG-1000, Instruction Manual

Page: 45 / 79

11
JOYSTICK [axis] = [Manual Input #]
Function: This command enables (+) or disables (–) the input from the default manual control
device for the axis (joystick or knob). If you specify an input device number
dev , the axis
specified will be connected to that input device. It’s an Axis-Specific Command.
The table below shows the valid device assignments:
0 NONE
1 DEFAULT
2 Joystick – X deflection (X-axis default)
3 Joystick – Y deflection (Y-axis default)
4 Standard Control Knob (Z-axis default)
5 X-Wheel (special hardware required)
6 Y-Wheel “
7 ADC CH1 – For ADC_FOLLOW or ADC_LOCK operation.
8 Foot switch
9 JX and X-wheel combo (special hardware required)
10 JY and Y-wheel combo “
11 CRIFF knob (used for CRIFF system)
22 Z-Wheel (TG-1000 only, right side of joypod)
23 F-Wheel (TG-1000 only, left side of joypod)
Reply: If there are no errors, the positive reply “
:A
” will be returned from the controller.
Example:
J X+ Y+ Z-
:A
The above command enables the default X and Y joystick control and disables the Z
control knob.
Example:
J X? Y?
:A X=2 Y=3
Here the query shows that the X & Y axes use the X & Y joystick driver.
To set a default value that can be saved in nonvolatile memory, add 100 to the
argument. Note that doing so only enables you to save the setting to nonvolatile
memory, but you must execute a
SAVESET
command to do so.
Example:
J X=105
:A
This makes X-Wheel the default X axis manual control device. This is a setting that can
be saved with the
SAVESET
command.