ashtech HDS800, Reference Manual

Page: 99 / 678

83
Using the Web Server
• If the external radio used is a standalone, radio
transmitter, skip this step. But if an ARF7474x license-
free radio is used, click on the
Connections
-
Radio
submenu and from the
Type
field located in the
External
Radio
pane, select the type of license free radio used.
Then click on the
Configure
button. You have now reached
the end of the configuration phase.
Ethernet Data
Streaming
Typically a base can be configured to deliver real-time
corrections to whoever asks for them through an IP
connection. This is achieved through the receiver’s Ethernet
port Ix.
The receiver is fitted with nine independent data outputs,
with the possibility for the administrator to define a specific
data format for each output.
In addition, for each data output, the administrator can
choose whether the base will be the server or the client in the
IP connection.
As a server (typical application), it will deliver its data to any
client asking for it and authorized to do so. Up to 5 different
users can be connected on the same port.
As a client (more specific), the base will start delivering its
data after it has been able to establish a communication with
the specified IP address.
Follow the instructions below:
• Click on
Base Setup > Data Streaming on IP
and define the
general parameters of the base, as explained in section
General Parameters on page
67
. Then proceed with the
steps below.
• Scroll down the page to display the Ethernet Streaming
frame.
• For each data stream the base should generate, enable the
Port Ix
option corresponding to the port you want to use.
Then in the same line, set the following fields:
HDS800
RTK Corrections
Ethernet
Ports I1-I9
Internet
(Server)
Users