ashtech HDS800, Reference Manual

Page: 94 / 678

78
Using the Web Server
• In the corresponding
Differential Stream x
pane, choose
Port
= “P - Ethernet” as the output port delivering the
generated differential data. In the
Message
field, choose
the type of differential message provided through this port
(ATOM, RTCM, CMR, CMR+ or DBEN).
NOTE: The receiver has been designed to offer two
separate and independent differential data outputs. Each
one can output a specific type of differential message. If
only one output is used, select
Port
=“None” for the other
output.
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver. You have now
reached the end of the configuration phase.
NTRIP Server Via
Modem
CAREFUL : In the RTCM sense, an “NTRIP server” is a source
of corrections feeding an NTRIP caster (see RTCM paper
200-2004/SC104-ST ). But from the point of view of the
network terminology, an “NTRIP server” is a client, not a
server.
The internal modem should be configured first:
• Click on the
Connections
menu and then on the
Bluetooth/
Modem
sub-menu.
• Set the following parameters in the
Internal Modem/Device
Settings
pane:
–
Power
: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic
: The modem will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual
: The modem will be powered up only by going
through the
Connections
>
Bluetooth/Modem
page and
setting the modem to “Power On” (or using the
$PASHS,MDM,ON command).
–
Automatic Connection
: Check this option.
Modem
HDS800
(Mobile Wireless
Communication)
Internet
(Client)
IP address
or server name
NTRIP Caster
Users