ashtech HDS800, Reference Manual

Page: 68 / 678

52
Using the Web Server
• Click on the
Configure
button to let the Web Server load all
your new parameters to the receiver. As a result, the radio
module is powered up.
Now that the radio is on, proceed with the last settings
required on the radio side.
• Click on the
Connections
menu and then on the
Radio
sub-
menu.
• In the
Internal Radio
pane, set the following parameters:
–
Power
: (it is now necessarily “On” as you have turned
on the radio in a previous step to make its
configuration possible.)
Choose whether the radio should be turned on
automatically or manually:
Automatic
: The radio will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual
: The radio will be powered up only by going
through the
Rover Setup
page, setting the internal radio
to “Power On” and clicking on the
Configure
button (or
using the $PASHS,RDP,ON command).
–
Channel
: Select the channel on which you know that
the base is transmitting its RTK corrections.
–
Protocol
: Select the data protocol used in the data
transmission:
“Transparent” or “DSNP” for U-Link Rx,
“Transparent”, “Trimtalk”, “Trimtalk450S”, “SATEL”,
“TrimMark II/IIe”, “TT450S”, “TRIMMARK3”,
“Transparent FST” or “DSNP” for Pacific Crest.
This choice should be the same as the one made at the
base.
–
Airlink Speed
: Choose the data transmission speed
(should be the same as the one used at the base).
– (
Type
is just a read-only field recalling the type of radio
used.)
–
Sensitivity
(U-Link and Pacific Crest): Set the radio
sensitivity level (“High”, “Medium” or “Low”)
–
Scrambler
(Pacific Crest): On or Off
–
FEC
(Pacific Crest): On or Off
–
Current Power
: (for ADL Foundation) 0.1, 0.5 or 1.0 W.
• Ignore the
External Radio
pane (
Type
should be set to “No
radio”).