ashtech HDS800, Reference Manual

Page: 655 / 678

639
Other Procedures & Memos
Through Bluetooth or a Serial Port on page 236 in this
manual to know how this can be done.
• Use the $PASHS,MDP serial command to configure serial
port A as an RS232 or RS422 port. Refer to MDP: Setting
Port A to RS232 or RS422 on page 3
3
9 in this manual to
learn how to use this command.
• Use the $PASHS,CTS command to enable/disable
hardware handshaking. Refer to MDP: Setting Port A to
RS232 or RS422 on page 3
3
9.
NOTE: A Bluetooth connection is also possible between a
Bluetooth-enabled computer and the receiver.
Enabling a Firmware Option
• Set up your equipment in such a way that it can
successfully receive and process a serial command sent
from outside the equipment. See
Applying Commands
Through Bluetooth or a Serial Port on page 2
3
6 in this
manual to know how this can be done.
• Use the $PASHS,OPTION serial command to enable the
firmware option. Refer to
OPTION: Receiver Firmware
Options on page
35
4 in this manual to learn how to use
this command.
Through this command, you will enter the code provided
by Ashtech after you purchased the option. Entering this
code into the receiver will unlock the option.
Decoding an NTRIP Source Table
The NtripCaster maintains a source table containing
information on available NtripSources, networks of
NtripSources, and NtripCasters, to be sent to an NtripClient
on request.
Source-table records are dedicated to one of the following:
• Data STReams (record type STR)
• CASters (record type CAS)
• NETworks of data streams (record type NET)
All data fields in the source-table records are separated using
the semicolon character (;), as a field delimiter. When a semi-
colon is part of the content, it is quoted (“;”)