44
Using the Web Server
$PASHR,ETH,I,ON,00:09:66:00:10:a0,10.20.2.123,DHP=1,ADD=192.168.
0.1,MSK=255.255.255.0,GTW=255.255.255.255,DN1=255.255.255.255,D
N2=255.255.255.255*3F
Should the Ethernet port be off (2nd parameter in the
above response line is “OFF” instead of “ON”), please use
the following command to turn it back on:
$PASHS,ETH,ON
Receiver response should be the following if the set command is successful:
$PASHR,ACK*3D
2. Send the following command to the receiver to disable the
DHCP mode and define an arbitrary IP address for the
receiver:
$PASHS,ETH,PAR,DHP,0,ADD,10.20.2.10,MSK,255.255.255.0,GTW,
10.20.2.1
$PASHR,ACK*3D
Where:
“10.20.2.10” is the arbitrary IP address assigned to the
receiver.
“255.255.255.0” is the arbitrary, but also mandatory,
subnetwork mask.
“10.20.2.1” is the arbitrary address for the gateway that
will be assigned to the computer.
3. On the computer (running Windows XP), from the task bar,
select
Start>Control Panel
.
4. Double-click
Network Configuration
.
5. Right click on
Local Area Connection
(or
Ethernet Board
if
there is no local network) and select
Properties
.
6. On the
General
tab of the
Local Area Connection
properties,
write down all the currently activated services so that later
you can easily revert to these settings.
7. Still in this dialog box, clear all the services, except for
the
Internet Protocol (TCP/IP)
service, which must stay
active.
8. Still in that box, select the
Internet Protocol (TCP/IP)
option
an click on the
Properties
button located nearby to open
the Internet Protocol Properties window.
9. In that window, disable the DHCP mode by selecting the
Use the following IP address
option.
10.Enter a different IP address for the computer (e.g.
10.20.2.2). Enter the same subnetwork mask and
gateway as those entered above in the receiver through the
$PASHS,ETH,PAR command.
Summary of Contents for HDS800
