ashtech HDS800, Reference Manual

Page: 428 / 678

412
Set Command Library
Enabling all signal observations to be output regardless of the
signal-to-noise ratio:
$PASHS,SOM,SNR,0*5B
Relevant Query
Command
$PASHQ,PAR
$PASHQ,SOM,SNR
See Also
$PASHS,SOM
$PASHS,SOM,NAV
$PASHS,SOM,CTT
$PASHS,SOMM,WRN
SOM,WRN: Channel Warnings Mask
Function
This command is used to mask the signal observations for
those signals flagged with channel warnings (MPC warning
bits are counted from 1 to 8). This means that only the
observations from non-flagged signals will be output (all the
others will be rejected).
This mask is enabled only after the “User-defined” option (9)
has been selected with the $PASHS,SOM command.
Command Format
Syntax
$PASHS,SOM,WRN,s1[,s2][*cc]
Parameters
Comments
• A signal is considered as flagged in at least one of the
following cases:
Parameter Description Range Default
s1 Differential data mask ON, OFF ON
s2
Raw data mask. If s2 is omitted, then the
receiver will assume s2=s1
ON, OFF OFF
*cc Optional checksum *00-*FF
Raw Data Masked by s2 Differential Data Masked by s1
MPC
DPC
ATM,RNX,SCN,0
All other messages