ashtech HDS800, Reference Manual

Page: 254 / 678

238
Using Serial Commands
Applying Commands Through TCP/IP
The receiver can be remotely controlled through its Ethernet
port.
By default, the Ethernet port is on and a default configuration
allows you to connect to the receiver via a non-secured TCP/
IP connection. However, if the Ethernet port is off and the
TCP/IP function has been deactivated or needs new settings,
follow the instructions below to set the Ethernet port.
Setting the
Ethernet Port
Run the following three $PASH commands through one of the
receiver’s serial ports. The syntax of the commands
mentioned below is fully described in the
Set Command
Library chapter.
The choices in the last two commands should be made in
collaboration with your local network administrator.
1. $PASHS,ETH,ON : This command allows you to power up
the Ethernet port. When the port is on, the Ethernet icon
appears in the lower-right corner of the receiver screen.
Script:
$PASHS,ETH,ON
$PASHR,ACK*3D
2. $PASHS,ETH,PAR : This command allows you to choose
either a static or dynamic (DHCP) IP address for the
receiver. If you choose DHCP, you don’t need to enter any
additional parameter.
Script:
$PASHS,ETH,PAR,DHP,1
$PASHR,ACK*3D
If you choose a static IP address for the receiver, the
command must also include the following parameters that
the administrator of your local network (LAN) should
provide you with:
• Static IP address
• Sub-network mask
• Gateway IP address
• DNS 1 IP address and DSN 2 IP address. These two
parameters are used to link the receiver name with an
IP address.