128
Web Server Help Files Collection
Configuration Tab
Network 2
Use this area to declare the type of connection used by the
base to distribute its data through the Internet (network 2).
See the description of each parameter in the table below.
Direct IP via port Q (Ethernet)
NTRIP Server via port Q (Ethernet)
Parameter
Designation
$PASHS
Connection
Choose the type of network connection used in the
receiver:
• None: No network connection used.
• Ethernet Direct IP - port Q: The base is connected
to the Internet through its Ethernet port.
• Ethernet NTRIP Server - port Q: The base is con-
nected to the Internet through its Ethernet port
using an IP connection to send its data to an NTRIP
caster. (The base is then a “client”.)
• Embedded NTRIP Caster - Port Q: (Available only if
the NTRIP caster option is installed): The base
delivers its data to the embedded NTRIP caster via
port Q.
MDM,..
NTR,PAR
DIP
Parameter
Designation
$PASHS
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
-
Address
IP address of the remote server
DIP,PAR
Port
IP port number of the remote server
DIP,PAR
Login
(Optional, depending on the remote server) Login
required to connect to the remote server
DIP,PAR
Password
(Optional, depending on the remote server used)
Password required to connect to the remote server.
If a login and password are needed for the connection
to the server, then the receiver will send the $GPUID
command to the server after you have entered these
two parameters and clicked on the Configure button.
DIP,PAR
Parameter
Designation
$PASHS
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
-
Address
IP address of the NTRIP caster
NTR,PAR
Port
IP port number of the NTRIP caster
NTR,PAR
Mount Point Mount point used to connect to the NTRIP caster
NTR,MTP
Password
Password required to send data to the NTRIP caster NTR,PAR
Summary of Contents for HDS800
