ashtech HDS800, Reference Manual

Page: 142 / 678

126
Web Server Help Files Collection
Configuration Tab
Network 1
Use this area to declare the type of connection used by the
base to distribute its data through a mobile communication
network or through the Internet (network 1). See the
description of each parameter in the table below.
Direct IP via port E (Modem) or port P (Ethernet)
Baud Rate
Choose a baud rate from the list. The selected rate
will be used by the port.
PRT
Mode
Port A only. Specify the type of serial link (“RS232 or
“RS422”) for Port A.
MDP
RTS/CTS
Check this button to enable the RTS/CTS handshak-
ing protocol on the port (if 232). Clear it otherwise.
CTS
Parameter Designation $PASHS
Connection
Choose the type of network connection used in the
receiver:
• None: No network connection used.
• Modem Direct IP - Port E: The base is connected to
a remote server (possibly RTDS) via Internet using
its internal modem and a Direct IP connection.
• Modem NTRIP Server - port E: The base is con-
nected to the Internet via its internal modem using
an IP connection for sending its data to an NTRIP
caster. (The base is then a “client”.)
• Ethernet Direct IP - port P: The base is connected
to the Internet through its Ethernet port.
• Ethernet NTRIP Server - port P: The base is con-
nected to the Internet through its Ethernet port
using an IP connection to send its data to an NTRIP
caster. (The base is then a “client”.)
• Embedded NTRIP Caster - Port P: (Available only if
the NTRIP caster option is installed): The base
delivers its data to the embedded NTRIP caster via
port P.
MDM,..
NTR,PAR
DIP
Parameter Designation $PASHS
Connect
Now
Check this button to let the receiver perform the
requested network connection after you have clicked
on the Configure button.
-
Address IP address of the remote server DIP,PAR
Port IP port number of the remote server DIP,PAR
Login
(Optional, depending on the remote server) Login
required to connect to the remote server
DIP,PAR
Parameter Designation $PASHS