Trouble Shooting Guide
Display is Flashing “E2”
Possible Causes
Possible Remedies: (Unplug stove
fi
rst when possible)
1. Air
fl
ow switch hose or stove attachment pipes for hose
are blocked.
Unhook air hose from the air switch and blow through it.
If air
fl
ows freely, the hose and tube are
fi
ne. If air will not
fl
ow throw the hose, use a wire coat hanger to clear the
blockage.
2. The air inlet, burnpot, interior combustion air chambers,
combustion blower, or exhaust pipe are blocked with ash
or foreign material.
Follow all cleaning procedures in the maintenance section
of the owner’s manual.
3. The
fi
rebox is not properly sealed.
Make sure the door is closed and that the gasket is in
good shape.
4. Vent pipe is incorrectly installed.
Check to make sure vent pipe installation meets criteria
in owner’s manual.
5. The air
fl
ow switch wire connections are bad.
Check the connectors that attach the gray wires to the air
switch.
6. Combustion blower failure.
With the stove on, check to see if the combustion blower is
running. If it is not, you will need to check for power going
to the combustion blower. It should be a full current. If there
is power, the blower is bad. If there is not, see #8.
7. Control board not sending power to combustion blower.
If there is no current going to the combustion blower, check
all wire connections. If all wires are properly connected,
you have a bad control board.
8. Control board not sending power to air switch.
There should be a 5-volt current (approximately) going to
the air switch after the stove has been on for 30 seconds.
9. Air switch has failed.
To test the air switch, you will need to disconnect the air
hose from the body of the stove. With the other end still
attached to the air switch, very gently suck on the loose end
of the hose (you may want to remove the hose entirely off
the stove and the air switch
fi
rst and make sure it is clear).
If you hear a click, the air switch is working. BE CAREFUL
TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH.
26
Summary of Contents for Ashley AP5660
Page 33: ...Wiring Diagram 33 ...
Page 35: ...Notes ...
