Ashida ADR241B, Instruction Manual

Page: 134 / 272

Doc ID : ADR241B-DO_IM_01
Ref ID : ADR241B/IM/CS
Rev No. : 06
Page No. : 134 of 272
ADR241B
IN 2 1 1 bit R 15602
IN 3 1 1 bit R 15603
IN 4 1 1 bit R 15604
IN 5 1 1 bit R 15605
IN 6 1 1 bit R 15606
IN 7 1 1 bit R 15607
IN 8 1 1 bit R 15608
Sr.
No.
Function
Code
Register No. of
Regs
Format Reg.
Type
Address
Map
5 Outputs 05
LED Reset 1 16 bit W 03025
Out 1 1 16 bit W 3028
Out 2 1 16 bit W 3029
Out 3 1 16 bit W 3030
Out 4 1 16 bit W 3031
Out 5 1 16 bit W 3032
Out 6 1 16 bit W 3033
Out 7 1 16 bit W 3034
Out 8 1 16 bit W 3035
Sr.
No.
Function
Code
Register No. of
Regs
Format Reg.
Type
Address Map
6 Parameters 03
IL1 2 32 bit Float R 33281– 33282
IL2 2 32 bit Float R 33283– 33284
IL3 2 32 bit Float R 33285 – 33286
IE 2 32 bit Float R 33287 – 33288
7.4 IEC60-870-5-103
The specification IEC 60870-5-103 (Tele control Equipment and Systems Part 5 Section 103:
Transmission Protocols), defines the use of standards IEC 60870-5-1 to IEC 60870-5-5,
which were designed for communication with protection equipment.
This section describes how the IEC 60870-5-103 standard is applied to the ADR241B Relay.
It is not a description of the standard itself. The level at which this section is written assumes
that the reader is already familiar with the IEC 60870-5-103 standard.
This section should provide sufficient detail to enable understanding of the standard at a
level required by most users.
The IEC 60870-5-103 interface is a master/slave interface with the device as the slave
device. The device conforms to compatibility level 2, as defined in the IEC 60870-5-
103.standard.
The following IEC 60870-5-103 facilities are supported by this interface: