Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture, please contact the dealer you purchased it from. To
validate the guarantee, please go to www.ashford.co.nz/product-registration
Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone 64 3 308 9087
[email protected] www.ashford.co.nz
INSTRUCTIONS
DOUBLE TREADLE KIT
ASHFORD TRAVELLER SINGLE OR DOUBLE DRIVE
Tools Required: Hammer, slot screwdriver, philips (pozi) screwdriver, candlewax, Ashford Spinning Wheel Oil.
Finishing the Wood: We recommend the wood surfaces be sealed before assembly. This protects the kiln dried wood from
climatic changes and enhances its beauty. Use either the Ashford Wax Finish or the same finish as the rest of your wheel.
Assembly Sequence: Please read these instructions right through before commencing.
1. Remove from the crank:
a) the split pin with a pair of pliers
b) the O-ring with a pin or needle
c) the E-clip with a small screwdriver. Take off old con rod from the crank.
2. Remove the hub pin. Use the nail provided and a hammer. Note: on earlier models the hub pin is in the middle of the hub.
Avoid damaging the spokes. Place a flat steel object such as pliers or a spanner over the nail and hammer it.
3. Remove the crank from the wheel. On old spinning wheels use a slot screwdriver to prise the bent 1/8” diameter hub pin out.
4. Remove the wheel from the frame. Clean the bearings and wheel. Remove any fibres that may have collected around the crank.
5. Remove the screw securing one front leg to the base.
6. Carefully twist and pull this leg from the frame. Note: it is possible this leg will be tight in the hole due to being a firm fit
when manufactured.
If it is tight:
a) Remove the other front leg (remove the screw first)
b) Hold the spinning wheel upside down by the leg. Protect the base with a piece of wood. Then tap the base with a
hammer. Two people may be necessary for this task.
DTKTV27012014V4
