It is always recommended to anchor the unit to the ground. Drill through
the four holes in the base of the unit using 6mm dia masonry drill to a
depth of 70mm. Screw in the anchor fixings. (These have a self cutting
thread). If not anchoring the unit, fit the self seal plugs BEFORE
BUILDING to block the fixing holes from underneath.
Please note
product must be anchored down to comply with LPS1175.
TOOLS REQUIRED
Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill and a
10mm socket or spanner.
ANNEXE
ZSCREW32
x4
ZSCREW100
x1
15
ZSCREW340
x18
32670
x12
6mm
Dia.
10mm
Spanner
18V
ZCOMPPLZS02
x4
ZCOMPPLAS22-23-24
x6
2x 2mm, 2x 3mm, 2x 5mm
RH DOOR 32613
x1
LH DOOR 32612
x1
FR
T PNL
TRAP
PLA
TE 32614
x1
LARGE FR
T P
ANEL
32610
x1
LH SIDE P
ANEL
32608
x1
RH SIDE P
ANEL
32609
x1
RH BACK P
ANEL
32607
x1
LH BACK P
ANEL
32606
x1
TOP
PANEL
32696
x1
BASE P
ANEL
32605
x1
FASCIA
3261
1
x1
RAIN GUARD 32615
x1
BASE INSTRUCTIONS
Flat and firm base. Recommended: concrete, tarmac or paving flags.
Min. distance from walls/ shrubbery: 1000mm.
Min. base size (WxDxH) 1990mm x 1100mm x 50mm.
LEVELING THE UNIT
Correctly level the constructed unit using the shims (ZCOMPPLAS)
provided prior to fixing the unit to the ground. Slide the packing pieces
under the corners of the unit base as required until an equal gap has
been achieved around the door allowing for its smooth operation and
alignment.
For maintenance instructions of this product visit www.asgardsss.co.uk
Warning: some panels may weigh over
20Kg. Beware of manual handling
Warning: Please keep
this key card safe! Refer
to if replacement key is
required.
x2
Posi-Driv
Screwdriver
00001
YOUR UNIQUE
KEY CODE
