Asentria SiteBoss 530 User Manual
16
Note:
The S530 does not heed changes to network configurations while you are connected to a command
processor via Telnet or web interface. Changes, including population of the candidate default router set, are
pended until all network-based command processor sessions have ended. Open FTP and RTS connections will
fail if these settings are changed during an open connection.
Name Resolution Settings
SiteBoss 530 - Name Resolution Settings
A) DNS Server 1 [0.0.0.0]
B) DNS Server 2 [0.0.0.0]
C) DNS Mode [MANUAL]
DNS Server 1
and
DNS Server 2
are the IP addresses of Domain Name Servers that you may want to configure
so that you can use host names rather than IP addresses in functions where name resolution may be needed,
such as; Email server, RTS push hosts, action IP settings, network time servers, etc. Default setting for each
DNS Server is 0.0.0.0.
DNS Mode
toggles between MANUAL, ETH1-DHCP, ETH2-DHCP and DSL. Default setting is MANUAL.
Web Interface Settings
SiteBoss 530 Web Interface Settings
A) Enable Web Interface [ON]
B) Web Session Timeout [30]
C) HTTP Connection Port [80]
D) HTTPS Connection Port [443]
Enable Web Interface
is an ON/OFF toggle to enable the S530's internal web server. Default setting is ON.
Web Session Timeout
sets the number of minutes (0 - 65535 minutes) a connection may remain idle before
expiring. A setting of 0 means the connection will never automatically expire. Default setting is 30.
HTTP / HTTPS Connection Port
is the TCP port through which HTTP and HTTPS connections are made.
Default setting is Port 80 for HTTP and Port 443 for HTTPS.
Connect using
http://<IP address of S530>
or
https://<IP address of S530>
to use Secure Sockets Layer
(SSL). You will be greeted by a login screen. Log in with your Login ID (Username) and Password. These are
the same credentials you would use to log into the command prompt. Once logged in, the General Status screen
will be displayed, with a menu bar across the top of the page that displays the same menu options as the
command prompt menu system.
Note:
If using SSL, the SSL certificate will show "localhost" as the name, which may cause a certificate
security warning to pop up, depending on the browser being used. The certificate may then be permanently
accepted so the warning doesn't appear each time.
Event Sensor Reporting Settings
SiteBoss 530 EventSensor Reporting Settings
A) EventSensor Report To IP []
B) EventSensor Report To Port [4000]
C) Enable EventSensor Reporting Host [OFF]
D) EventSensor Reporting Host Port [4000]
Event Sensor Report To IP
sets the IP address of the host S530 a sensor connected to this S530 would report to.
Summary of Contents for SiteBoss 530
Page 6: ......
