ASEM HMI30, User Manual

Page: 28 / 91

22
SECTION 3 – Installation and connection
Note:
please refer to paragraph 2.3 Package .
3.1 Preparation for installation
3.1.1 Select the mounting location
Points to observe when selecting the mounting location:
a) Position HMI30 to avoid exposure to direct sunlight.
b) Position HMI30 such that it is ergonomically accessible for the operator.
c) Choose a suitable mounting height.
d)
Ensure that the ventilation holes are not covered.
3.2 Checking the package contents

Check the package content for visible signs of transport damage and for
completeness.

In the case of damaged parts, contact your ASEM representative. Do not
install parts damaged during shipment.
3.3 Checking the operating conditions

Read carefully the standards, approvals, EMC parameters and technical
specifications for operation of the HMI device. This information is availa-
ble in the following sections:
o
Certificates and approvals (see section 8).
o
Electromagnetic compatibility (see section 8).

Check the mechanical and climatic ambient conditions for operation of
the HMI device: Ambient conditions (see section 8).

Follow the instructions for local use of the HMI device: Notes about us-
age.

Adhere to the permissible rated voltage and the associated tolerance
range:
o
24V
o
Range: 18÷36 V
DC