ASDA BLACK RADIO ALARM CLOCK MODEL KS - 108
Digital radio tuning
Bright red LED digital display.
No battery back-up in case of power failure.
Not able to store stations on the radio.
12 hour display, with “pm” led on to show PM
Plug in mains. Display flashes 12:00
To set time, press “time set”. The red digital time display flashes. Press “hours”
and “minutes”. Display continues to flash for 2-3 seconds, then is steady and the
time is now set.
Listen to the radio: Extend the small thin black wire as high as possible. It is the
FM aerial. To help AM reception, rotate the radio left or right, its aerial is inside
the device. Each time you press “clock/fm/am”, the device rotates around the
three states.
To tune in the radio, press and hold “” or “tuning -” for 2 seconds and
radio will auto tune to next radio station. If you know the frequency, keep
pressing until frequency is displayed. You cannot store stations. Adjust the
or -.
To set alarm. Radio must be off.
Press “alarm set” quickly once. Digital display flashes. Press “hours” and
“minutes” to display required alarm time. There is also a small red LED “alarm”
which flashes on and off. This small red LED is steady when an alarm is set.
Select the time quickly, because if no buttons are pressed for about two seconds,
the alarm time is stored and the flashing “alarm” LED is now steady, showing the
alarm time is set and the alarm is now on.
Be aware also that the type of alarm has also to be selected. The alarm can be the
radio, either FM or AM, or can be a loud buzzer. To select the type of alarm, when
you are in the alarm setting mode (with the digital display flashing) press the
“alarm mode” button and each press will rotate selection of “FM/AM /Buzzer”.
There are small red LEDs to show what is being selected as your alarm.
To check the alarm time at any time just press once the “alarm set”. The digital
display will flash with the alarm time and show whether FM,AM or buzzer is
primed.
You may cancel the alarm at this or any point by pressing “alarm mode”, or you
can change the alarm time from its setting by following the above stages,
resetting the new time whilst the large display is still flashing.
SNOOZE: Going to bed…switch the radio on, then press “snooze” button to select
how long before radio switches itself off. Each time the “snooze” button is
pressed, you will see a countdown display of the time in ten minute intervals
from 90 mins down to “off” before the radio will switch off for the night.. If you
just press “snooze” once, the radio will play for 90 minutes and then switch off.