Ascon Tecnologic - AET1 - USER MANUAL - Vr. 1.0 PAG. 1
AET1
TTL To EThErnET TCP/IP
GaTEway
User Manual
Code: ISTR-MAET1ITAENG01 - Vr. 1.0 (ENG)
ascon Tecnologic S.r.l.
Viale Indipendenza 56, 27029 Vigevano (PV) - ITALY
Tel.:
+39 0381 69871 -
FaX:
+39 0381 698730
site:
www.ascontecnologic.com
e-mail:
ForEword
D
D
This manual contains the information necessary for
the installation, use and maintenance of the product,
we therefore recommend that the utmost attention is
paid to the following instructions and to save it.
This document is exclusive property of Ascon Tecnologic
which forbids any reproduction and divulgation, even in part, of
the document, unless expressly authorized. Ascon Tecnologic
reserves the right to make any formal or functional changes
at any moment and without any notice.
Ascon Tecnologic and its legal representatives do not
assume any responsibility for any damage to people, things
or animals deriving from violation, wrong or improper use or
in any case not in compliance with the instrument features.
D
D
Whenever a failure or a malfunction of the device
may cause dangerous situations for persons, thing
or animals, please remember that the plant must be
equipped with additional electromechanical devices
which will guarantee safety.
Disposal
The appliance (or the product) must be disposed
of separately in compliance with the local standards
in force on waste disposal.
1 oUTLInE dIMEnSIonS (mm)
TTL
PWR
RX
TX
27.80
87.50
95.30
31.18
DIN rail
mounting
78.65
21.55
M4
Screw mounting
holes
M4
TTL
PWR
RX
TX
A
B
Connectors
detail
1.1 Mounting requirements
This instrument is intended for permanent installation, for
indoor use only, in an electrical panel which encloses the rear
housing, exposed terminals and wiring on the back. Select a
mounting location having the following characteristics:
1.
It should be easily accessible;
2.
There is minimum vibrations and no impact;
3.
There are no corrosive gases;
4.
There are no water or other fluids (i.e. condensation);
5.
The ambient temperature is in accordance with the
operative temperature (0... 50°C);
6.
The relative humidity is in accordance with the instrument
specifications (20... 85%).
2 ConnECTIon dIaGraM
2.1 General notes about wiring
Do not run the communication cables (TTL or Ethernet)
together with power cables.
2.2 TTL Connection
2.2.1 Cable identification
Cable models:
CATTL D020;
Identification:
Both side with a black tube.
P1
1
5
P2
1
5
BLACK
BLACK
2.3 Ethernet Connection
The Ethernet connection is made with a standard Ethernet
cable with RJ45 connectors.
3 how To ProCEEd
1.
Connect the CATTL cable to the instrument that must be
connected to the Ethernet network;
2.
Power ON the instrument;
3.
Plug the second side of the CATTL into connector
B
;
4.
If the LED
Pwr
turns ON, the connection is correct,
otherwise, disconnect the CATTL cable from
B
connector
and plug it into connector
a
;
5.
The LED
Pwr
turns ON.
