1
Carefully unpack box and make sure you have all items
shown below.
1 of 4
2
Unlock and open front panel
of unit for wiring and setup.
What’s what?
Important components labeled
Ascent Camera
For automatic and on-demand photo capture
Power and Relay Terminals
For wiring to power and gate operator
and/or door opener. See
Page 2
.
Relay Status LEDs
Relay is active when lit
Antenna Cables
SIM Card
If you have your own SIM card, see
Page 4
and follow the instructions entitled,
Installing a Third-Party SIM Card
.
Status and Event Terminals
For wiring to check gate status and for
request-to-exit devices. See
Page 3
.
Wiegand Device Terminals
For wiring to Wiegand-compatible devices
such as a proximity card reader.
See
summitcontrol.com/resources
.
WARNING!
AUTOMATIC GATES CAN CAUSE
SERIOUS INJURY OR DEATH!
ALWAYS CHECK
that the
GATE PATH
IS CLEAR BEFORE OPERATING
!
Reversing or other safety devices
should
ALWAYS BE USED
!
IMPORTANT!
r
Ascent
WILL NOT WORK
until the
activation process is
COMPLETE
!
Follow the
Activation Guide
or call
Summit Control
at
(844) 259-8265
to
activate your unit.
Continued on next page...
Please use
all four screws
when mounting unit to pedestal. Leave “hockey puck” antenna
in place, even if using extension. Seal any holes or gaps created in unit enclosure.
Failure to follow these instructions can result in damage to the unit!
CAUTION!
Unit shown with front panel fully open.
Internal wiring not shown for clarity.
Ascent Unit
Key
Carriage Bolt
( x4 )
Hex Nut
( x4 )
12-V AC/DC Adapter
(PS-12DC1)
Model
25-K2
We recommend mounting Ascent on a
gooseneck pedestal using included hardware.
If using alternate mounting, two (2)
Ascent 10' Cable Extension
(p/n 16-X-EXT)
products should be purchased and installed.
Failure to do so may result in NO SIGNAL!
IMPORTANT!
r
QUICK START
GUIDE
