Under this interface, users can decide whether to multiplex the channel encoding stream.
YES
means that the device multiplexes the encoding stream into the MPTS, while
NO
means that the
output program is SPTS. The LCD will display the following pages after pressing
ENTER
key.
1.1.4.1 Channel Mux 01/01
[ YES] NO
4.2.2
ASI Settings
Users can check the ASI input program amount in this interface, and the LCD will display the
following page. Prog: 006 means the input program is 6 and Out: 003 means 3 of the 6 programs
have been multiplexed.
►
2.1 Parse ASI Prog
4.2.3
Output Setting
By pressing the
ENTER
key in the main editing interface, users can set the device output parameter.
The device will display the following page after users pressing the
ENTER
key.
2.1 Parse ASI Prog Prog: 006 Out: 003
►
001 HK1
√
002 HK2
X
►
3.1 IP Out Enable 3.2 IP Out Address
3.3 IP Out Port 3.4 Trans Stream ID
►
3.5 Output Stream3.6ASI Output
3.7UTC Time Config 3.8 Null PKT
►
3.9 TS Package Num
Solutions Provider for FTTx, RFoG and HFC www.ascentcomtec.com
Page 39 of 89
