AT5000 2.6GHz DMOD Optical Transmitter
Solutions Provider for FTTx, RFoG and HFC www. ascentcomtec.com
Page 6 of 27
Always keep a protective cap on unplugged fiber connectors.
Always store unused protective caps in a resealable container in order to prevent the
possibility of the transfer of dust to the fiber. Locate the containers near the connectors
for easy access.
Always discard used tissues and swabs properly.
Warnings
Never use alcohol or wet cleaning without a way to ensure that it does not leave residue
on the endface. It can cause damage to the equipment.
Never look into a fiber while the system lasers are on.
Never clean bulkheads or receptacle devices without a way to inspect them.
Never touch products without being properly grounded.
Never use unfiltered handheld magnifiers or focusing optics to inspect fiber connectors.
Never connect a fiber to a fiberscope while the system lasers are on.
Never touch the end face of the fiber connectors.
Never twist or pull forcefully on the fiber cable.
Never reuse any tissue, swab, or cleaning cassette reel.
Never touch the clean area of a tissue, swab, or cleaning fabric.
Never touch any portion of a tissue or swab where alcohol was applied.
Never touch the dispensing tip of an alcohol bottle.
Never use alcohol around an open flame or spark; alcohol is very flammable.
ACT AT5226 1RU 2.6GHz 1550nm Direct-Modulated (DMOD) Laser Transmitter offers a flexible
and scalable optical transmission for high quality CATV & SAT-IF video in short, medium
distance FTTH networks. It was designed with high linearity and low chirp DFB laser, with
built-in pre-distortion compensation and AGC close loop control for improved performance.
AT5226 DMOD series transmitters are capable of delivering analog and digital video
transmission up to 15km, all Digital loading up to 45km, with intuitive front panel LCD display
to make operator’s daily operation easier. The optical transmitter is packaged in a self-
contained 19” sub-rack of 1 RU with universal mains power supply and SNMP management.
The optical output power level can be ordered at either 6 dBm, 8dBm or 10dBm with single or
dual power supply for redundancy. Combined with ACT AT5200 Multiport EDFA optical
amplifier, AT5226 DMOD transmitter provides the most cost effective solution for short,
medium IPTV, VOD and traditional CATV & SAT-IF services in HFC & FTTX networks.
