3-28
Preliminary November 4, 1998
MAX 4000 Series Hardware Installation Guide
Quickstart
Gathering configuration information
Table 3-6. E1 line configuration information
Parameters
Your setting
Comments
Sig Mode
Enter the type of signaling your line uses:
•
None—A leased line.
•
ISDN—ISDN signaling using the D
channel. The 32nd channel of the E1 line
must be designated as the D channel.
•
DPNSS—The interface supports DPNSS
or DASS 2 signaling.
•
R2—R2 signaling.
•
Metered—Metered R2 signaling protocol,
used in Brazil and South Africa.
•
Chinese— A version of the R2 signaling
protocol specified for use in China.
•
Malaysia indicates a version of the R2
signaling protocol with CLID processing
specified for use in Malaysia.
Get this information from your service
provider.
Switch Type
In a Net/E1 profile, specify one of the
following values:
•
GloBanD—Q.931W GloBanD data
service
•
NI-1—National IDSN-1
•
Net 5—Euro ISDN services in Belgium,
the Netherlands, Switzerland, Sweden,
Denmark, and Singapore
•
DASS 2—U.K. only
•
ISLX—DPNSS switch type
•
ISDX—DPNSS switch type
•
Mercury—DPNSS switch type
•
Australian—Australia only
•
French—VN3 ISDN PRI
•
German—1TR6
•
CAS—New Zealand
Framing Mode
For each line, select G.703 (the default) or
2DS. Get this information from your service
provider.
If you select G.703, the MAX provides CRC-4
checking. If you select 2DS, it does not.
