ASC - Refining the way we listen.
REVISED 1-11
Step 1: Materials
Parts Supplied
Tools Required
. 2 CablePassThru Units
. Drill
. #2 Phillips Bit
. Tape Measure
. Pencil
. Sharp Knife
. Stud Finder
. Keyhole Saw
. 12 2” Bugle Head
Drywall Screws
. Rubber Seal in
Cardboard Tube
CablePassThru
I
n s t a l l a t I o n
Step 2: Placement
Using your studfinder, determine a spot on your wall between studs to install your CablePassThru. Ensure
that the placement is clear of any wires, ducting, or plumbing, as we need a clear path through the the wall.
Step 3: Prep for Cut
Once placement is determined, hold the CablePassThru up to the wall. Level the unit using a Torpedo Level
(Fig. 1). While continuing to hold it in place, use a pencil to trace the outline of the inner sleeve (Fig 2).
*Use included Wall Cutout Template to verify and adjust size as needed for correct fit.
Fig. 1 Leveling the Unit
Fig. 2 Tracing Inner Sleeve
Fig. 3 Checking Hole Size
Step 4: Cut CablePassThru Hole
Use keyhole saw to cut out the hole traced in Steps 2 and 3. Cut out any insulation that may be in the wall where
the hole is. Then use a long drill bit or similar tool to indicate the corners of the hole on the other side of the wall.
Use the keyhole saw to cut the second hole on the other side of the wall.
4275 West 5th Ave. Eugene, OR 97402 Phone: 541.343.9727 Fax: 541.343.9245 acousticsciences.com