6
asberprofessional.com
asberprofessional.com
To convert your range, follow the directions below
1.
Check that the main gas supply has been shut off and the power supply cord is
disconnected.
2.
Remove main top.
3.
Convert pressure regulator. Your range is equipped with a convertible pressure regulator.
To convert, follow the illustrations below for the type of regulator on your range.
2.4.4
PRESSURE REGULATOR CONVERSION
Failure to install the pressure regulator will void the appliance warranty
2.5
Location
• Installation of the equipment should be performed by qualified, certified, and authorized personnel
who are familiar and experienced with local installation codes.
• Before Installation please read instructions completely and carefully.
• Do not remove permanently affixed labels, warnings or plates from the product.
• Please observe all local and national codes and ordinances
• Installation must conform with local codes, or in the absence of local codes, the National
Fuel Gas Code, ANSI Z223.1 (latest edition)
• The appliance must be isolated from gas supply piping system, by closing its individualmanual shut off
valve during any pressure testing of the gas supply piping system at test pressure equal to or less than
½ psi (3.45kpa)
A. Remove cap and snap out plastic plunger from bottom of cap.
B. Turn plunger over and snap back in original location.
C. Re-insert the cap assembly into the regulator and tighten.
