Asami AMV5-22SLD, Owner'S Manual, Page: 20 / 28

Multi Variable Air Conditioners Floor and Ceiling Type Indoor Unit
16
so that the single-core wire can be exposed.
2) Use a screwdriver to remove the terminal screw on the terminal board.
3) Use a plier to bend the end of single branch line until it forms a circle that has a similar size with the
screw.
4) Lead the screw across the circle of the single branch line and fix it on the wiring board.
2 Connection of Multi-twisted Wire(shown in Fig.5.1.2)
1) Use a wired stripper to strip away about 10mm of the insulation layer at the end of multi-twisted
wire.
2) Use a screwdriver to remove screw on the wiring board of air conditioner.
3) Use a round terminal fastener or a plier to securely fasten the round terminal with each core wire of
the multi-core wire.
4) Confirm each position of core wire on the round terminal and then use a screwdriver to tighten the
terminal screw.
Fig 5.1.1 Fig 5.1.2
5.2 Power Cord Connection
Note:
Power supply of each indoor unit must be from the same source.
Fig 5.2
Remark: The maximum number of indoor units that can be connected depends on the capacity of outdoor
unit. For specific details, please refer to the capacity configuration part.
1 For air conditioner that uses single-phase power
1) Remove the cover of electric box of indoor unit.
2) Lead the power cord across the rubber ring.