31
Guide bar and handlebar
1
2
3
1. Slacken the screw for the height adjust-
ment of the handlebar (
1
) and pull it out
sideways.
2.
Attention:
Do not crush the Bowden
cables (
2
) when swivelling the handlebar.
Swivel up the handlebar (
3
) to the correct
working position and tighten with the screw
and nut.
Storage
Storing the device
Keep the device in a closed, dry, and well vent-
ilated room and out of reach of children. Al-
ways eliminate all problems of the device be-
fore you store it so that the device is always in
a safe-to-operate state. Let the engine cool
down before you store the device in closed
rooms.
Longer storage
1.
Observe the safety instructions for hand-
ling the fuel.
2.
Emptying fuel tank. Place a piece of hose
onto the fuel valve and let the fule run into
an approved fuel container.
3.
Emtyping carburetor: Start the engine and
let it run until it stops by itself.
4.
Thoroughly clean the device.
5.
Touch up any possible damage to the
paint finish (for paint, see Accessories).
Before longer storage, e.g. in the fall, have an
authorised service centre check the device!
Restarting
If you want to start the device after a longer
storage, carry out the tasks described in
chapter Maintenance.
Spare parts
The reliable and safe operation of the device
also depends on the quality of the spare parts
used. Only use original spare parts and ac-
cessories that were approved by
“AS-Motor Germany”. When foreign parts are
installed, the warranty and guarantee shall be
void for the foreign part and for the device and
for any resulting damage.
Inform your authorised service centre about
the device type and serial number of your
devices when you order spare parts.
