AS MOTOR 021917080011, Operator'S Manual

Page: 24 / 48

24
Loading
Use suitable ramps for loading that
– can carry the empty weight of the
200 kg.
– are wider than the device.
– have a slip-free surface.
Notice
Risk of damage due to incorrect fastening of
straps.
► Fasten the straps only at the points
shown in the figure.
► Do not overtighten the straps.
1. Put the device in front of the ramps and
make sure that the ramps
– are as wide as the wheel gauge of the
device.
– are tightly secured to the platform.
– are not steeper than 15°.
2. Carefully drive the device via the ramps
onto the platform.
3. Observe the instructions in chapter
Switching on and stopping.
4. Secure the device against rolling, sliding
and tilting. Use straps that support the
weight of the device.
Fig. 6:
Fig. 7:
Fig. 8:
5. Secure the device with belts to the frame
elements that can hold the weight
Unloading the device
1. Slacken the transport attachments.
2. Carefully drive the device over the ramps
off the loading area.
Observe the information in chapter Loading.
Towing
Warning
The device can roll away without the drive.
► Never unlock the drive in steep terrain
without securing the device against
rolling away.
If the engine cannot be started again, the
device must be towed.
1. While using the brakes, let the device roll to
terrain that is less steep.
2. Secure the device against rolling or sliding.
3. Secure the device with a cable winch that
has got enough load capacity.
4. For towing, unlock the drive and release
the parking brake.