Aruba MSR4K43N0, Installation Manual

Page: 36 / 43

MSR4000 Installation Guide 35
4. Place the seal bolt (6) over the Ethernet cable.
5. Strip off about 55mm (2 inches) of the outer Ethernet cable sheath to expose the ground
wire and other pair wires.
6. Insert all pair wires into the two shield rings (5).
7. Make the ground wire attach to the narrow end of the inner ring and place the outer ring
over the narrow end of the inner ring.
8. Insert the Ethernet cable into the narrow end of the clamp ring and pass it through the
opening end of waterproof connector socket.
9. Using a crimping tool, attach the included shielded RJ45 connector.
10. Slide the shield rings up the Ethernet cable and insert it into the narrow end of the clamp
ring.
11.
Pull the Ethernet cable so the shielded RJ45 connector fits into the RJ45 shaped
opening in the wide end of the weatherproof connector socket.
Note
For outdoor use, the RJ45 must be installed with a waterproofing gasket.
12. Slide the sealing bolt over the narrow end of the clamp ring and hand tighten it.
13. Thread the sealing nut onto the sealing bolt.
14. Insert the Ethernet cable connector into the Ethernet interface and hand-tighten the
locknut.
15. Water-proof the Ethernet cable connection with PVC insulation tape and adhesive tape.
Figure 4-15 Connecting Ethernet Cable to the Ethernet interface