AT-S60 Command Line User’s Guide
81
ENABLE SNMP AUTHENTICATETRAP
Syntax
enable snmp authenticatetrap
Parameters
None.
Description
This command configures the switch to send authentication failure traps
to trap receivers. The switch sends an authentication failure trap
whenever a SNMP management station attempts to access the switch
using an incorrect or invalid community string, or the management
station’s IP address has not been added to a community string that has a
closed access status.
The default setting for sending authentication failure traps is enabled.
Refer to
on page 70 to enter the IP addresses
of the trap receivers.
Example
The following command configures the switch to send authentication
failure traps to trap receivers:
enable snmp authenticatetrap
