Aruba AP 80 Outdoor Wireless Access Point
11
Installation Guide
Provisioning Access Points
Chapter 3
N
OTE
:
If you have location-specific configurations for your Access Points, you
will need to apply this configuration information using AP Reprovisioning.
Refer to the
User Guide
for details on AP Reprovisioning and see the
feature description below.
AP Provisioning
AP Reprovisioning is the process by which Master and Slave APs are assigned,
for example, location codes. Location codes are important for recalibration and
triangulation. For details on AP Reprovisioning, see the
User Guide
.
AP Provisioning is useful for brand new APs with default configurations. To
perform AP Provisioning from the GUI:
1.
Go to
Maintenance > Program AP
.
On this window, there are two tabs:
Provision
and
Reprovision
. The
Provisioning tab is selected by default.
F
IGURE
3-1
Provisioning Tab
2.
Configure the APs
Subnet
and
Netmask
.
This is the subnet from which the AP gets an IP during provisioning. (This is
not the IP address the AP will use when deployed. Also, the provisioning
subnet should be not be the same as an existing subnet on the Mobility
Controller.)
3.
Select the
Port
or Port range for provisioning.
