Aruba 800-E, Installation Manual

Page: 29 / 52

Aruba 800-E 21
Installation Guide
Configuring the 800-E From
the WebUI
4
The essential steps you must take to configure your Access Multiplexer are:
„
Verify the IP settings
„
Configure the VLANs to be tunneled (on both ends of the tunnel)
„
Configure the ports supporting tunneled VLANs
„
Configure the Mobility Controller (local or master) to support the 800-E
Verify the Multiplexer IP Settings
To verify that the setup dialog configuration is correct:
1. Navigate to Configuration > Switch page.
2. Select the IP Routing tab.
F
IGURE
4-1 IP Configuration
Make changes as necessary.