Aruba Networks AirOS v2.3, User Manual

Page: 173 / 254

Intrusion Detection 163
Chapter 10
Configuring Ad-hoc Network Protection
The table below describes the parameters in this section.
Configuring Wireless Bridge Detection
To configure detection of wireless bridges, navigate to
Configuration > WLAN Intrusion
Detection > Policies > Wireless Bridge
, as shown in the figure below.
The table below describes the fields in this section.
Misconfigured AP Protection: To configure protection of misconfigured APs, navigate to
Configuration > WLAN Intrusion Detection > Policies > Misconfigured AP,
as shown in
the figure below
Field Description
1. Enable Adhoc Networks Activity
Detection Enable detection of Ad-hoc networks.
2. Enable Adhoc Network
Protection When Ad-hoc networks are detected, they will be
disabled using a denial of service attack.
3. Adhoc Detection Quiet Time
(secs) After an alarm has been triggered, the amount of time
that must pass before another identical alarm may be
triggered.
Field Description
1. Enable Wireless Bridge Detection Enable detection of Ad-hoc networks.
2. Wireless Bridge Detection Quiet
Time (secs) After an alarm has been triggered, the amount of time
that must pass before another identical alarm may be
triggered.