9.4.2. Change the duration
After all notes are released, the corresponding Matrix buttons turn blue. There are several
ways to change the duration of the notes.
9.4.2.1. All notes
With all notes released, turn the Amount knob clockwise to lengthen all of the notes in the
step. Those notes are now tied into the following steps. The blue LEDs to the right indicate
the length of the tied notes. This is also visible in playback mode.
Now turn the Amount knob counter-clockwise; fewer blue LEDs means the notes are shorter.
if a note is extra long you may need to keep turning the knob before anything changes.
9.4.2.2. One note
Press and hold a blue button, then turn the Amount knob to edit the length of a single note
in a chord.
9.4.2.3. Proportional changes
It's possible to add a note, extend it with the Amount knob, then add another note, etc., and
extend them proportionately.
9.4.2.4. Remove notes
Press the left-most blue button of a row to remove that note from the chord.
9.4.3. Select a purple step
Touch one of the purple buttons: it turns red to show it is the current step. Add one or more
notes and adjust their duration, or select another purple button instead.
9.4.4. Exit step edit
When you're done, you can press the red step or the Record button to exit step record. This
returns you to the home page. To confirm the changes, re-enter step record and press that
red step to hear it.
9.5. Step record: Mods
The movements of up to three controls can be recorded on the Modulation tracks, live or
in step mode. The controller data can be added or edited on each step. Live recording is
covered
; in this section the focus is Step recording. For this example, start with a
sequence that has no Modulation tracks recorded.
First, stop the pattern (if it's playing), then press the Record button to enter step record mode.
Use [Assign 4] to select Modulation view. You can switch back to Notes view using [Assign 3]
at any time.
70
Arturia - User Manual PolyBrute - Step Record / Edit
Summary of Contents for PolyBrute
Page 1: ...USER MANUAL...
