5. THE TOP PANEL
This chapter covers the synthesizer features of the MiniBrute 2S: the oscillators, the filter,
the envelopes, etc. Click the following links for descriptions of the
, the
and
, and the
settings.
5.1. The LFOs
An LFO is low frequency oscillator that can produce various waveforms at sub-audio
frequencies (0.0625Hz up to 100Hz). The MiniBrute 2S provides two LFOs, each with
waveform choices of sine, triangle, sawtooth, square, two types of random waves.
Each LFO has its own Wave selector, Rate control, a switch that determines whether it will
run freely or synchronize to the master clock.
♪
: LFO 1 and 2 are identical, so this section of the manual applies equally to both.
5.1.1. Wave
The LFOs offer several types of modulation waveforms. The selection is made by the
Wave
knob: sine, triangle, sawtooth, square, random stepped (also referred to as Sample & Hold),
and random gliding (or smoothed random).
•
Sine
rises and falls smoothly between its minimum and maximum values
•
Triangle
rises and falls in more of a linear manner between its minimum and
maximum values
•
Sawtooth
falls to its minimum value in a linear manner and then rises suddenly
to its maximum value
•
Square
rises and falls suddenly between its minimum and maximum values
•
Random stepped
rises and falls suddenly between values that are generated at
random
•
Random gliding
rises and falls gradually between values that are generated at
random
The LFO 1 section
28
Arturia - User Manual MiniBrute 2S - The top panel
Summary of Contents for MINIBRUTE 2S
Page 1: ...USER MANUAL...
