ARTURIA – JUPITER-8V – USER’S MANUAL
102
200 ms) and, finally, lower the Sustain toward «0.0.600.000». The maximum level
of the cut off frequency is thus reduced.
Increase the attack time
Increase the position of the «PWM» selector (for «Pulse Width Modulation») to the
center of its range. Place the situated switch to the right of the «PWM» selector on
the position «LFO». Now it is set to modulate the width of the square with the LFO.
Increase the position of the «PWM» selector
Increase the position of the LFO «Rate» slider to a position around 3 Hz. The
achieved effect will be comparable to a chorus effect.
Increase the position of the LFO rate slider
At this stage, you can add a little «Stereo Delay» effect to your tone in order to
make it sound wider.
Open the «Effects» page situated in the top panel of the Jupiter-8V.
In the first «Patch» slot (at the bottom of the connection diagram of the effects),
choose the «ST Delay».
Set the times («Time») for each of the two sides of the stereo delay.
Summary of Contents for JUPITER-8V 2
Page 1: ...ARTURIA JUPITER 8V USER S MANUAL 1 USER S MANUAL 2 0 ...
Page 24: ...ARTURIA JUPITER 8V USER S MANUAL 24 It s now time to launch Jupiter 8V2 ...
Page 88: ...ARTURIA JUPITER 8V USER S MANUAL 88 Dual Phaser ...
Page 121: ...ARTURIA JUPITER 8V USER S MANUAL 121 Connection from a MIDI track to Jupiter 8V ...
