9.10.2.5. Wait to Load Pattern
With this parameter you can specify whether a new pattern will be loaded as soon as you
select it or not. If not, DrumBrute Impact will wait until the end of the current pattern before
switching to the next one.
♪
: This parameter can also be toggled from the front panel of the DrumBrute Impact by holding the
Shift button and pressing Step button 14 (At End).
9.10.2.6. Accent Velocity Threshold
This sets the MIDI velocity value for the Accents you add when editing a pattern. This also
determines the accent level response when a MIDI note is received.
9.10.2.7. Pads send MIDI notes
You can choose whether the pads will send MIDI note data or not. The available options are
Off (no MIDI note data sent), USB&MIDI, USB and MIDI. The actual note values they will
send are determined by the Drum Map. See
for more information.
9.10.2.8. Sequencer sends MIDI notes
You can choose whether the sequencer will send MIDI note data or not. The available
options are Off (no MIDI note data sent), USB&MIDI, USB and MIDI. The actual note values
they will send are determined by the Drum Map.
of the manual to
learn more about it.
9.10.2.9. Metronome
Seven metronome values are available, including one that cannot be accessed from the
front panel (1/4T, or quarter-note triplets).
9.10.2.10. Step Repeat Randomizer
This setting will allow Random to act on the Step Repeat value. When On it will randomly
change the Step Repeat value (add or remove repeats on events). When Off Random only
affects the velocity and existence of events.
9.10.2.11. Step Repeat Probability
The Probability parameter allows you to increase or decrease the likelihood that a random
Step Repeat event will occur. At higher levels it also can generate Step Repeats where none
existed before.
95
Arturia - User Manual DrumBrute Impact - MIDI Control Center
Summary of Contents for DRUMBRUTE IMPACT
Page 1: ...USER MANUAL...
