11
AHLINK
If the device does not appear
on the window, the AHlink
signal is not active. To activate
it, press during 5 seconds the
Up and Down button located
on cover plate. If your unit still
does not appear, power cycle
the unit and press again during
5 seconds the Up and Down
button.
The AHlink name always begin
by “AH” characters and the
fourth last MAC AHlink address.
Select the device to control and
to configure the unit.
Selecting the device, the first
page is uploaded on the cell
phone. This page is used to
check the device and also for
basic diagnostic during the
installation process.
