Artesyn PCIE-7210-2-32GB, Installation And Use Manual, Page: 32 / 82

Hardware Preparation and Installation
32 SharpStreamer
TM
Pro Installation and Use (6806800V01B)
2.4.1 ESD Prevention
Static electricity may cause injury or damage the device. To minimize the damage, pay
attention to the following points:

Before touching the card or electronic components, make sure that you are working
in an ESD safe environment.

Before you operate the device, wear the ESD-preventive wrist strap. Both terminals of
the ESD preventive wrist strap must contact well. One terminal touches your bare skin,
and the other is inserted in the jack at the front or back side of the shelf.

Avoid moving as much as possible. Movement gathers static electricity around you.

Do not touch the solder point, pin, or bare circuit.

Do not leave the device in the place where others can operate it.

Install the device at once after you take it out of the anti static package. If you need to
lay down the device, place it back in the anti static package. Do not lay the device on
the shelf or cabinet.

Monitor the temperature and humidity of the equipment room. Warm air decreases
the humidity but increases the static electricity in the room.
2.5 SharpStreamer Pro Card Installation and
Removal
This section contains the SharpStreamer Pro card installation and removal procedures.
Use ESD
Wrist Strap
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage
circuits or shorten their life. Before touching the module or electronic components,
make sure that you are working in an ESD safe environment.
Shipping the card along with a server is not recommended.
If you need to ship the card with the server, make sure the card is properly secured in the
server. Necessary precautions must be followed to keep the card stable to avoid damage
to the card.
For more information about securing the PCIe card in a server, refer to MaxCore product
documentation.