Artesyn MaxCore MC1600, Installation And Use Manual, Page: 88 / 118

86 MC1600 Extreme Edge Server Installation and Use (6806870A02A)
Software Configuration
Software Configuration
When CPU1 boots, a DHCP configuration is created and the DHCPD service is started. This
allows CPU2 to PXE boot from CPU1. See the following figures for the single and dual default
network diagrams.
Table 5-2 Dual CPU Variant
CPU Interface Description Default IP Address
CPU1
ETH1 Front panel interface 172.26.1.10
bcm Network interface from CPU1 to the Broadcom switch Not configured
xlink Network interface to CPU2 172.27.1.10
CPU2
ETH2 Front panel interface 172.26.1.20
bcm Network interface from CPU2 to Broadcom switch Not configured
xlink Network interface to CPU1 DHCP enabled
Figure 5-1 Single CPU Variant
CPU 1
ETH1 = 172.26.1.10
ETH2 = not configured
Broadcom Switch
bcm interface
ETH1
ETH2
Front
Panel