Artesyn MaxCore MC1600, Installation And Use Manual, Page: 75 / 118

Site Preparation
MC1600 Extreme Edge Server Installation and Use (6806870A02A) 73
2.3.2 Dimensions and Weight
The table below lists the dimensions and weight of the Extreme Edge Server with system
components installed.
2.4 ESD Prevention
To minimize the damage to the product pay attention to the following points:

Before touching the card or electronic components make sure that you are working in
an ESD safe environment

Attach an ESD-preventive wrist strap before operating the product. Both terminals of
the wrist strap must contact well. One terminal touches bare skin and the terminal
with the alligator clip attaches to the grounding lug at I/O panel of the system.

Avoid moving as much as possible. Movement gathers static electricity around you

Do not touch the solder point, pin, or bare circuit

Do not leave the product in an area where others can operate it

Install the product right after you take it out of the anti-static package. If you need to
lay down the product, replace it into the anti-static package. Do not place the product
on the shelf or cabinet.

Monitor the temperature and humidity of the equipment room. Warm air decreases
the humidity but increases the static electricity in the room.
When installing additional blades or modules, make sure that the power consumption of
all installed modules does not exceed the system's maximum power dissipation.
Table 2-2 Dimensions and Weight of System
Component Dimensions W x H x D Weight
Server including DIMMs, M.2 SSDs, mounting
ears, and PCIe filler panel
1U (H) x 19” (W) x 12” (D)
(44.5mm x 482.6mm x 304.8mm) 12.4 lbs
(5.6 kg)