Artesyn MaxCore MC1600, Installation And Use Manual, Page: 74 / 118

72 MC1600 Extreme Edge Server Installation and Use (6806870A02A)
Site Preparation
Site Preparation
2.3 Prepare the Installation Site
This section provides the basic site planning and installation requirements.

440W power should be available for the MC1600 system

System should be positioned so that a power source is easy to reach

Sufficient space should be available in racks to install the system

Suitable equipment should be available to lift the system into the rack

Enough space should be available to run a system console terminal

Cable should be long enough to reach the system

Make sure the inlet and outlet of the Extreme Edge Server is not blocked

System should be installed in a restricted access location

System should have access by trained personnel only
Make sure that all defined environmental and power requirements are met. Refer to
Electromechanical on page 75 and Environmental on page 75 .
2.3.1 Power Requirements
Make sure that a suitable -40 to -57VDC power source is within reach of the system. Two
independent power feeds can be connected to the system.
Table 2-1 System Power Requirements
Feature Value
Voltage and input current
Voltage:
-40 to -57VDC (SELV)
Current:
1x11A maximum
Chassis idle power 170W
Chassis maximum power 440W