Artesyn AXP1440, Installation And Use Manual, Page: 100 / 156

AXP1440 Shelf Installation
98 AXP1440 Installation and Use (6806800H23U )
Procedure - Power Up the System
Follow these steps to power up the system:
1. Push the PEM circuit breakers to the ON position.
2. Verify that all FRU LEDs illuminate and the PEM’s In Service LED is green.
The system executes its normal start-up routine and is then ready to use.
5.11 Accessing the System
You can access your system using the SAM shelf manager. The SAM-1500 direct serial console
connector (back of chassis) is an RJ-45 connector on the SAM face plate. This connector is
configured as DTE. The indirect serial console connector (front of chassis, located on the ADP)
is a 9-pin micro-D subconnector. For default user name and password, contact your Artesyn’s
sales representative.
Custom cables are required for these connectors. Refer to RS-232 Serial Interface on page 132
for pin assignments.
5.12 Upgrading Firmware
Upgrading firmware on the AXP1440 shelf involves the following components:

IPMC firmware on the two Fan Tray Modules (FTMs)

IPMC firmware on the two Power Entry Modules (PEMs)

Shelf Manager firmware (including an FPGA image) on the two SAMs
5.12.1 FTM IPMC Firmware Upgrade
NOTE: The upgrade process described here uses a script named upgradeftm, which is
supplied on shelf managers starting with build 4.1.0-3.
There is a single IPMC firmware image common to the two FTMs in the AXP1440. The FTM
IPMCs are assigned IPMB addresses 0x56 and 0x58.