Artesyn ATCA-7360, Installation And Use Manual

Page: 239 / 288

Supported IPMI Commands
ATCA-7360 Installation and Use (6806800J07S)
239
8.4.1 Get Status Command
The Get Status command can be used by the payload software to retrieve the status of the
IPMC.
Table 8-26 Get Status Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00
5 Bit [7] Graceful Reboot Request
If set to 1, indicates that the payload is requested to initiate the
graceful reboot sequence.
Bit [6] Diagnostic Interrupt Request
If set to 1, indicates that a payload diagnostic interrupt request
has arrived.
Bit [5] Shutdown Alert
If set to 1, indicates that the payload is going to be shutdown.
Bit [4] Reset Alert
If set to 1, indicates that the payload is going to be reset.
Bit [3] Sensor Alert
If set to 1, indicates that at least one of the IPMC sensors
detects a threshold crossing.
Bits [2:1] Mode
The current IPMC modes are defined as:
0: Normal
1: Standalone, for a description refer to
Table 8-25
2: Manual Standalone, for a description refer to Table 8-25
Bit [0] Control
If set to 0, the IPMC control over the payload is disabled.